Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Air Duct Repair for Denton Homeowners
Leaky, torn, or collapsed ducts waste the money you spend on heating and cooling, and they pull attic dust and insulation fibers straight into the rooms where your family sleeps. If your vents feel weak, your energy bills have climbed, or you’ve noticed dust settling faster than it used to, the duct system itself may be the problem. We repair what others just clean around. Our technicians have up to 11 years of experience, and we use professional-grade equipment rather than portable consumer kits. When a run is disconnected, crushed, or torn, we can often get to it the same day. Call (888) 890-4255 to book an assessment. We answer 24/7, with fast dispatch from 7am to 7pm.
HVAC Duct Installation
HVAC Duct Installation means building and fitting the full duct system that moves conditioned air from your equipment to every room, and it comes up when a home has no ductwork, when a renovation adds rooms the existing layout can’t reach, or when a system is being reconfigured. It’s a design job as much as a labor job: trunk sizing, branch runs, register placement, and return capacity all decide how even the airflow feels once the system runs. We plan the layout around your floor plan and equipment capacity, then seal and support every joint so the system performs as intended. Typical cost for a partial installation runs $1,200 to $3,500 depending on the number of runs and how much attic access the job requires; a whole-home install is quoted by written estimate after we walk the layout. Estimates are free.
Planning the Layout
We map trunk lines and branch runs before anyone cuts material, matching duct size to the air your equipment actually moves. Rooms that are hard to reach, like additions over garages, get sized carefully rather than guessed at. The plan is reviewed with you before work starts so there are no surprises.
Sealing and Support
Every joint we install gets sealed, and runs are supported at proper intervals so they don’t sag over time. Sagging ducts restrict airflow and collect dust at the low points. Sealed, well-supported ductwork is what keeps the system quiet and efficient.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Air Duct Replacement
Air Duct Replacement means removing a failed duct system and installing new ductwork in its place, and it’s usually the right call when the existing runs are deteriorated past the point where patching makes sense. Older flex duct in Denton attics takes a beating from summer heat, and the material itself degrades over time: the inner liner separates, the outer jacket tears, and insulation breaks down. Once that happens, sealing tape and patch jobs only buy a little time. We pull out the old runs, dispose of the material, and install new sealed ductwork sized for your system. Partial replacement typically runs $800 to $2,800 depending on how many runs are involved and how accessible the attic is; full replacement is quoted after inspection. The written estimate sets the final price.
Tell-Tale Signs It’s Time
If you can see visible tears in the duct jacket, find insulation debris in your registers, or the system only moves air well when every door is open, replacement is worth considering. Collapsed flex duct that won’t hold its shape is another sign. We inspect first and tell you plainly whether repair or replacement is the better path.
What New Ductwork Changes
New, sealed runs restore airflow to rooms that went weak and stop attic air from being drawn into the living space. Homeowners often notice quieter operation and more even temperatures room to room. It also gives the equipment a healthier workload.
Ductwork Repair
Ductwork Repair covers the fixes that stop a system from bleeding air: resealing joints and seams, reconnecting disconnected runs, repairing tears in flex duct, and re-supporting sagging sections. It’s the most common scope of work we see in Denton, and it matters because the average duct system loses a meaningful share of its conditioned air through gaps before it ever reaches a register. The leaks pull in attic dust, insulation fibers, and whatever else is sitting in the space around the ducts. We locate the failures, seal them with mastic and proper tape, and verify airflow afterward rather than assuming the fix held. Most individual repairs run $150 to $600 depending on access and how many leaks are found. Every price comes from a written estimate agreed before work starts.
Finding the Leaks
We trace airflow loss through the system, checking connections at the plenum and every branch takeoff. Attic runs get inspected along their full length, since flex duct often tears where it bends or rests against framing. The findings are explained to you with photos.
Sealing That Holds
Sealing is done with materials made for ductwork, not whatever tape is on hand, and every patch is checked against the system running. That matters because a repair that fails the first hot week isn’t a repair. We test before we call the job done.
Duct Replacement
Duct Replacement is the broader project of swapping out duct sections beyond a single run, typically the trunk line or a whole zone of the system, when multiple sections fail at once or the existing layout can’t be salvaged with targeted fixes. It differs from small repairs in scale: it involves removing and reinstalling trunk or branch sections, reconnecting the system, and rebalancing airflow afterward. This comes up when a system has had repeated repairs, when a renovation left ductwork mismatched to the equipment, or when crushed and disconnected runs are found in the same area. We size the replacement to your equipment and seal the new work completely. Trunk replacement commonly runs $1,000 to $3,000 depending on length and access. Call (888) 890-4255 for an exact quote.
Where Replacement Beats Patching
When repairs keep repeating in the same stretch of duct, replacement usually costs less than chasing the failures one at a time. Badly crushed or disconnected sections fall into the same category, especially where heat exposure has made the material brittle. We say so honestly when that’s the case.
Keeping the System Balanced
New duct sections change airflow, so we check the balance across the system after installation. Registers that were weak before should improve, and rooms that got too much air shouldn’t overcorrect. The goal is even comfort throughout the home.
Ductwork Installation
Ductwork Installation covers fitting new duct runs where none existed or extending a system into new space, and it’s a different job from replacement in one key way: there’s nothing to tear out, so the layout is planned from scratch. That means coordinating with whatever equipment is already in place, designing the run path, and making every connection airtight the first time. We handle this for additions, converted garages, and reconfigured floor plans where the original duct layout no longer reaches. We’re also familiar with Honeywell and Aprilaire systems, so if your home has whole-home filtration or humidity control in place, the ductwork we install accounts for it. A smaller installation typically runs $1,200 to $3,500 depending on the number of registers and the distance from the equipment. Larger projects are quoted by written estimate.
Working Around Your Home
Installation work is planned to keep disruption contained, with work areas protected and a clear plan for what gets moved. We walk the route with you before we start cutting. You’ll know what each day’s work involves.
Matching the Equipment
Duct size has to match what the equipment can move; oversize runs waste space and undersize runs choke the system. We calculate the required airflow rather than copying whatever the last installer did. That’s how the system ends up quiet and even.
Brands We Service
We work with Honeywell and Aprilaire air quality equipment regularly, and we know how those systems interact with ductwork. Whole-home filtration and humidity control both depend on airtight, correctly sized ducts to perform the way they were designed, so when we repair or install ductwork we plan around the air quality hardware already in your home rather than treating it as an obstacle. We’re familiar with Aprilaire humidifiers and filtration cabinets and with Honeywell controls and media filters, so the ductwork we fit leaves those systems working properly.
We also use Abatement Technologies negative-air practices during duct work in Denton, which keeps dislodged contaminants from recirculating through the house while sections are open. That matters most in older homes where the ducts have never been cleaned and the debris load is high. Whether you have Honeywell or any other make, we can help.
See the difference
Before
After
Before
After
Before
AfterSigns You Need a Pro Right Now
- Whistling or roaring vents. A high-pitched whistle usually means pressure is escaping through a gap that’s too small for the airflow. Roaring vents point to undersized or crushed runs. Either way, the system is working harder than it should.
- Dust settling faster than usual. If surfaces need dusting within a day or two, the supply ducts may be pulling attic or crawlspace air into the living space. That’s debris you’re breathing.
- Uneven room temperatures. A room that never heats or cools like the rest of the house often has a disconnected or torn duct feeding it. The equipment is running fine; the delivery system isn’t.
- Visible damage at the registers or in the attic. Torn flex duct jacket, separated joints, or insulation debris at the register all point to duct failure. These are worth fixing before the system runs through another summer.
- Rising energy bills with no other explanation. Escaping air is paid for twice: once to condition it and again to condition the replacement air pulled in through the leaks. A duct inspection is the quickest way to find out.
Our Process, Step by Step
- 1
Inspection and airflow checks. We start by inspecting the full duct system and measuring airflow at the registers. Static pressure readings tell us whether the equipment is strained. Findings are documented with photos.
- 2
Camera inspection where needed. Sections we can’t see clearly get looked at with a camera so nothing is assumed. Hidden tears and disconnected joints turn up this way. You see what we see.
- 3
Written estimate before work begins. You get a flat price for the agreed scope, not an hourly rate that drifts. Nothing starts until you’ve approved it in writing. That’s the whole point of the estimate.
- 4
Repair or installation with containment. Work is done with Abatement Technologies negative-air practices where the scope calls for it, and with Rotobrush and Nikro equipment where the ducts are being cleaned as part of the job. Contaminants stay contained. Work areas stay protected.
- 5
Final verification and photos. We recheck airflow and confirm the repair holds under operation, then share before-and-after photos of your own ductwork. You’ll know exactly what was done.
How Much Does Air Duct Repair Cost in Denton?
Air duct repair in Denton typically costs $150 to $600 for small fixes like resealing joints or reconnecting a single run, and $800 to $3,000 or more for larger scopes like trunk replacement or installing new ductwork for an addition. The written estimate sets the final price, and there’s no charge for the estimate itself.
What moves that range: how many leaks or failed sections are found, whether the ducts are reachable from a walkable attic or require crawling through tight spaces, and whether the material is flex duct or rigid metal, since metal takes different repair methods. Homes that have never had duct cleaning often add that scope, which changes the total. A typical duct cleaning in Denton visit that catches a torn run is where a lot of these repairs begin.
To avoid overpaying, treat any quote given over the phone before an inspection with caution, and be skeptical of a low figure that climbs once work starts. Ask for the price per job in writing with the scope listed. Our free estimate includes the inspection, airflow readings, and a flat price for the agreed scope, so the number on the estimate is the number you pay. We don’t quote per vent, because whole-system pricing is the only honest way to do it. Call (888) 890-4255 and we’ll get an inspection on the schedule. Estimates are free.
Our Service Area Near Denton
We serve homeowners in Denton and the surrounding communities, including Double Oak, Krum, Corinth, Argyle, Lantana, Lake Dallas, Oak Point, Hickory Creek, and Highland Village. Most of these are a short drive from Denton proper, and we schedule inspections with a clear arrival window rather than an all-day estimate. Where older flex duct is common in the area’s attics, we often find the same failure patterns: brittle jackets, separated joints at the plenum. If you’re in any of these towns, call and we’ll get you on the schedule.
Serving Denton, TX – Our Local Coverage Area
We serve Denton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Air Duct Repair in Denton
Air duct repair is the work of fixing damage in the duct system itself so conditioned air reaches your rooms instead of leaking into the attic or crawlspace. It covers resealing joints, reconnecting disconnected runs, repairing tears in flex duct, and re-supporting sagging sections. It’s different from duct cleaning, which removes debris but doesn’t fix structural failures. If your ducts are both leaking and dirty, we handle both in one visit.
Most single-run repairs take one to two hours, while a larger scope like trunk replacement or partial reinstallation can run a full day. The estimate you approve states the expected time so you can plan around it. Access matters most; an easily reached attic job moves faster than one requiring tight-space work. We’ll tell you upfront.
Small fixes typically run $150 to $600, and larger jobs involving trunk or partial replacement run $800 to $3,000 depending on scope and access. The written estimate sets the final price, so the number you approve is the number you pay. We don’t charge per vent or add fees after the fact. Call (888) 890-4255 for an exact quote. Estimates are free.
Yes. We work with Honeywell and Aprilaire equipment and understand how whole-home filtration and humidity control depend on tightly sealed ductwork. If your system has a media filter cabinet or a humidifier tied into the ducts, we plan the repair around it so nothing is compromised. We’re familiar with these systems rather than guessing at them. Bring it up when you call and we’ll factor it in.
Often, yes. If you call with a failing duct and the schedule allows, we can frequently get a technician out the same day. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening.
Our work is backed by a satisfaction guarantee: if the repair we made doesn’t perform, we come back and make it right. The details are spelled out in the written estimate, including what’s covered and the timeframe. We’d rather fix it properly than have you chasing us. Ask any question about coverage before you approve the work.
Clear access to the attic or crawlspace opening and make sure anyone home knows when the technician is expected. If you have pets, secure them away from the work area during the visit. Move anything stored on top of the attic hatch. That’s usually all it takes.
Schedule Your Air Duct Repair Service in Denton Today
Leaking or damaged ducts don’t fix themselves, and every month they run costs you on the energy bill. We’ll inspect the system, show you the problem with photos, and give you one flat price for the agreed work before anything starts. If you’re in Denton or nearby, call (888) 890-4255 for a no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm.
Written by the team at Duct Cleaning Denton.